Washer nozzles wanted..

[ptdreamer]

Anyone have any suggestions for a set of non-lighted nozzles. I want the chrome look, but I'm not lookin' to light 'em up. I've found a couple of generic sets, but they're way oversized. All help greatly appreciated.

[Cal Cruzer]

I think I am just going to paint mine body color.

[sakigt]

Gary found chrome covers if I remember correctly. Do a search on his thread about it.

[PTGT Redman]

chrome covers are ok, but don't stick very well, and are a grit trap.
paint the ones you have.

[Gary04GT]

Here is a great inexpensive ($9) MOD--these chrome washer nozzle covers work fine, have not become a "grit trap" so far, and most people who see them ask me where I got them as they look very SHARP. [|)] Make sure you clean the surface well and install when the temperature is 50 degrees F (or more)--you can use a hair dryer to heat the surface if you like--these will stay on "forever". If you decide you don't like them later on then just use a hair dryer to heat the 3M adhesive tape and remove. [8D]

Check them out at this thread:
http://www.ptcruiserlinks.com/forum/...ozzle, covers

[ptdreamer]

Actually I ordered a set of the covers from PT Warehouse - Thanks Gary
$9 and free shipping. As for temp, living in San Antonio in August, I think the hood should be warm enough to get a good seal on the adhesive.