![]() |
Advertisements
|
|
Register | FAQ | Members List | Social Groups | Calendar | Search | Today's Posts | Mark Forums Read |
Site Home | Forum Home | Photo Gallery | PT Events | PT Videos |
Advertisements
|
|
![]() |
|
LinkBack | Thread Tools | Display Modes |
|
|||
![]()
help....headlamp (low beam) out....bulbs new and fuses good...both under dash and under hood....wiring looks solid ...no breaks or shorts
|
|
|||
![]()
Throw a volt/ohm meter on the prongs on the light terminal and see
1) if you're getting 12 volts with the lights on 2) if the ground is continuous to chassis Kind of unclear from your post if one or both are out though(post says 'headlamp' in the singular). If both sides are out, I'd go straight to the headlight power relay. If that's good, replace the turn signal stalk. If just one side, then use the volt/ohm meter to track it down. |
|
|||
![]()
only the right side (psgr. side) is affected....no voltage being shown at the socket
|
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Haze headlamp lens | stirfry | General PT Cruiser Discussions | 12 | 22 Nov 2004 04:10 pm |
Who was looking for Hella headlamp pods? | TripleJackInGA | Exterior Accessories Forum | 6 | 28 Jan 2004 06:29 pm |
New Euro four Headlamp Kit - 2 sets in stock | rally performance | Vendors & Buyers Forum | 3 | 12 Nov 2003 12:21 pm |
This is the factory headlamp sealer | TripleJackInGA | Exterior & Interior Styling | 3 | 23 Jul 2003 02:17 pm |
This is what the factory uses to seal the headlamp | TripleJackInGA | Exterior Accessories Forum | 0 | 21 Jul 2003 03:16 pm |