PT Cruiser Forum   Car Videos
Custom Wheels | Free Car Insurance Quote      

Go Back   PT Cruiser Forum > 2.4L Turbo Forums > Stage Turbo Kits

PT Cruiser Forum

HELP Stage one question

 
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 09 Aug 2004, 10:40 pm
Fresh Cruiser
 
Join Date: Feb 2004
Location: Hawthorne, new york.
Posts: 21
Default HELP Stage one question

Old Reader, and guy...Here is my question, Stage one is in box , waiting till Sat. to do install, I have played with my car a little and was wondering should I put the car back to the way I got it or leave the "upgrades" alone. Not that I did much, ex: I am sure I could leave the "Baffles" from the air-box to turbo OUT! But what about the MBC, and the "Black-Line Trick (that I got off this form-THANX) When I installed the MBC- I blocked the brown line( to the turbo) and replace it with the "other" line form MBC ( the other of course is vac.) Please any help would be GREAT!! Thanks for all you HELP!!!
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
  #2 (permalink)  
Old 10 Aug 2004, 05:23 pm
Fresh Cruiser
 
Join Date: Jan 2004
Location: .
Posts: 11
Default

Scottman, #1 remove neg.batt.cable before starting this project. I removed air box and turbo up tubing. Cover turbo inlet with clean rag. All plugs(4auto,3stick)can be removed. 10mm scoket, short extenion. I used 1/4in drive. INSTALL like you removed. Instructions say to do a brake in with your trans,DO it. "I" would do it with out boost controller pluged in. Your in for one nice ride. You will smile as wide as your grill.
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
  #3 (permalink)  
Old 10 Aug 2004, 10:44 pm
Fresh Cruiser
 
Join Date: Feb 2004
Location: Hawthorne, new york.
Posts: 21
Default

Thanks!!!!!!
so i will take out MBC, what about the other line??? Should I replace back to stock? or it will not matter?
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
  #4 (permalink)  
Old 11 Aug 2004, 01:23 am
Cool Cruiser
 
Join Date: May 2004
Location: Los Alamitos, CA, USA.
Posts: 431
Default

Scottscars, ajoeb, welcome to both of you. Scott, do a search on Stage I and you can get some good hints as to what to expect. I installed S I last week-en and the biggist problem was getting the connectors off. The red tabs slid bac OK but the connectors were hard to get off. Pull out and down with some force and they come off OK. I had to remove my strut brace but the UCP and AirforceOne staid on. Watch out for the clip that holds the windshield washer tube near the cowel. I got a deep cut on that mother.

If you have an 04 GT you just have the PCM, but it now has four bolts instead of three. And, there are two wire harness attachment points on the PCM brackets.

Good Luck! [8)] [?]
__________________
Inferno Red \'04 GT Autostick, Stage I, BTG exhaust, Airforce One intake, V.A.K. Candy Red upper charge pipe, BTG strut bar,Hyperground, chrome side spears and grill accents.
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
  #5 (permalink)  
Old 11 Aug 2004, 08:29 am
Senior Cruiser
 
Join Date: Apr 2003
Location: Jacksonville, FL, USA.
Posts: 1,235
Send a message via AIM to sakigt
Default

I took my BC off, but I doubt I needed to. I just wanted to see if teh car ran the same without it. I did, but it was a tad slower.
__________________

14.67 @ 94.5 <--- Self Proclaimed Fastest East Coast PT with Black wheels!!!
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Stage 1 question stranger Stage Turbo Kits 1 01 Sep 2006 07:59 pm
Stage 1 Question? cycletron General Turbo Discussions 4 26 Sep 2005 11:50 am
Stage 1 kit question DREAM2 Stage Turbo Kits 5 17 Apr 2004 10:59 am
Stage 2 Question Mean Green Stage Turbo Kits 10 20 Mar 2004 07:54 pm
Stage 1 time question AA PT Stage Turbo Kits 11 02 Dec 2003 06:20 pm


All times are GMT -5. The time now is 01:49 am.




Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
LinkBacks Enabled by vBSEO 3.3.1 © 2009, Crawlability, Inc.
vB.Sponsors

  Wordpress Theme | Find jobs | Wordpress Theme | Debt Consolidation | Wordpress Themes