rear wiper problem

[rrgsj]

my rear wiper just stopped working after about ten minutes of operation.
my column switch seems to be working ok as it will dispense washer fluid but wiper will not run. Is there a fuse that controls this action. I checked all fuses and they seem to be ok. I went and bought another motor, installed it and still have the same issue. Can anyone help::

[CREWZIN]

When you put the new motor in did you check the wiring to see if there's power that's getting back to the motor? You didn't say what year your PT is and it DOES make a difference. The No.#15 interior fuse in the 01-05 PT's is for the wipers but not sure if that front and rear.

[rrgsj]

Crewzin,

thanks for responding, I have not checked the power and the year is 2006. I will check to see if power is getting to the source. Still not sure if there is a fuse linked to the rear wipers. the man isn't very clear and is abrev. Thanks again for your response.

[rrgsj]

jcc

there was no seal that came with the motor. I reused the one that was there in place. sorry no part #

[CREWZIN]

jccc,

I don't know if this will help or not. My parts catalog isn't very clear on that particular part. On the illustrations it points to everything else but that, but on the parts list, it mentions a Grommet: part no, 5027 551AA. That may be your rubber seal or not.

rrgsj,

The No #15 fuse is only for the 01-05 cruisers. Everything is changed from 06 up. There's a complete new circuit card with fuses on the newer models and I have no catalogs or books on the changes.