![]() |
|
|
|||||||
| Register | FAQ | Members List | Social Groups | Calendar | Search | Today's Posts | Mark Forums Read |
| Site Home | Forum Home | Photo Gallery | PT Events | PT Videos | Car Videos | Parts Search |
|
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|||
|
Where is it & how do you get to it?
|
|
|||
|
Went over to PTCrew & found out there isn't one on the 03. I had checked in my 2003 Daimler Chrysler Corporation Service Manual & couldn't find one. So being the genius i am i looked in the Hanes manual & there it is. Went to Advanced auto & they sold me a gasket for it. I am chasing a vacuum leak. Believe i found it. The upper intake to lower intake manifold gasket has a track from the outside to the inside around #4. Chasing Misfire #4 cylinder. Does anyone think i should go deeper?
|
|
|||
|
The 03 GT doesn't have an EGR valve. If you are still using stock plug wires get rid of them. I'm using Bosch Premium plug wires with a life time warranty. I don't like champion plugs as they leak, and went to NGK 2315.Tie wrap all vacuum lines, especially down by the turbo and brake boost. One reason I went with the plastic intake manifold is the o-rings instead of the gaskets used on the aluminum manifold, and less heat sink.
|
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2003 turbo engine vibration | Ldesiano | General Turbo Discussions | 8 | 30 Mar 2009 09:44 am |
| How lucky was I? (BOV install) | alceryes | General Turbo Discussions | 27 | 18 Jul 2004 11:29 am |
| 2003 TURBO UP, COLD AIR INTAKE | amx1397 | Vendors & Buyers Forum | 1 | 18 Nov 2003 05:39 am |
| 2003 PT Turbo Review by AUTOTEST FILE | Gary04GT | General Turbo Discussions | 2 | 12 Jul 2003 09:14 am |
| Chrysler to Offer New Cheaper GT Turbo | skylight | PT Cruiser News and Rumors | 19 | 12 Jun 2003 02:04 pm |