PT Cruiser Forum  
Advertisements
       

Go Back   PT Cruiser Forum > General Forums > Tech & Performance Forum

PT Cruiser Forum

Advertisements
no error codes

 
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 14 Aug 2009, 01:58 pm
Regular Cruiser
 
Join Date: Apr 2008
Location: palm bch county fl
Posts: 107
Default no error codes

Cruising down the road my stereo keep turning itself off and on power wise,then the car stalled at every light until i powerbraked it.Then i notice i was not shifting gears{auto stick} looked down at speedo and its stuck at 15 mph,drove 6 miles home in first gear, with the dash selector saying i,m in all gears,park reverse,nuetral and drive.I get nothing from error codes but done.Oh but once home going in and out of park to any gear it goes in hard.
Any ideas??? Rob...aka lt4supr...thanks

Last edited by lt4supr; 14 Aug 2009 at 02:01 pm.
Reply With Quote
  #2 (permalink)  
Old 14 Aug 2009, 02:33 pm
Travis2k7's Avatar
Cool Cruiser
 
Join Date: May 2009
Location: Seattle, WA
Posts: 406
Default Re: no error codes

Limp home mode?
__________________
2006 Limited, Auto, 100k miles
Reply With Quote
  #3 (permalink)  
Old 14 Aug 2009, 03:49 pm
Regular Cruiser
 
Join Date: Apr 2008
Location: palm bch county fl
Posts: 107
Default Re: no error codes

Well heres one,after getting concerned about on off my toys its back to normal..yaaaaaa.reset the system by disconnecting neg side of battery nothing.Could not find fuse for e.c.m anywhere. i came across a fuse marked
a/stick ignition in interior fuse panel 10 amp lower rght,and it had a wire from the underbody neonlight stuck into the side of it.pulled fuse out and it was blown replaced it without the neon light wire and it now shifts right and reads one gear im in instead of all of them..
So for all auto stick cars if you get a reading on the dash telling you your in all gears but stuck in second gear here it is..a/stick ignition 10 amp fuse.

Lucky me Rob...aka lt4supr
Reply With Quote
  #4 (permalink)  
Old 14 Aug 2009, 07:27 pm
Obsessed Cruiser
 
Join Date: Sep 2001
Posts: 27,744
Default Re: no error codes

Who wired the undercar neons?
__________________
Rules of the forum have been updated as of *07/07/2019* Please read them over.

- All decisions by the Moderator are semi-permanent, can and may be changed at his discretion but definitely will be the final word. Any action performed by the Administrator or Moderators are not to be discussed on the forum.
Reply With Quote
  #5 (permalink)  
Old 14 Aug 2009, 07:34 pm
Regular Cruiser
 
Join Date: Apr 2008
Location: palm bch county fl
Posts: 107
Default Re: no error codes

past owner and did a very bad job of it as far as the way he gained a power source it was hidden way up under the dash.But the bottom line was when that 10 amp fuse blow the weird reaction it caused..just drove it to dinner and all is back to nomal.

Rob
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -5. The time now is 10:11 am.




Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
LinkBacks Enabled by vBSEO 3.6.0 PL2 © 2011, Crawlability, Inc.
vB.Sponsors