Tapping into turn signal circuit

[Stephen R.]

I need to tap into a couple of circuits:

1. Right & left turn signals

2. Parking light

I'm looking for an easy-to-access interior location, but not under that crazy dash! Also need to know the method of fishing wires from interior to door speakers. Sounds easy to do, but it's not...

[OurPTGT]

didja check PTDIY?

Kevin & Donna's Elec Blue GT

http://www.dreamcruisers.org/index/Page_1x.html

[2sb]

There's probably an easier way, but here's how I fished wires. With door panel off, disconnect existing wires to give yourself some slack. Squish the accordian tube at the door and work it off the door hole. It's basicly like a grommet. Stretch it some to straighten, then run the new wires from inside the door out thru the tube to inside the car. With it straight and stretched, it's fairly easy to fish a wire thru. Then pulling the slack out, squish and reinsert the tube in the door.

[ceaesq]

In mounting and connecting Muth wide angle signal mirrors on my GT, I routed wires the same as 2sb through the door rubber tube. The turn signal wires can be tapped underneath the door edge trim piece on each side of the car. On the 03 it was a green wire w/brown stripe on the driver's side, and a brown wire w/ red stripe on the passenger side.

[Stephen R.]

Thanks for jogging my long-term memory: http://www.ptdoityourself.net/ptmuthguide.html