Who's has the fastest pt-gt. in the 1/4 or 1/8

[old head from phila.]

My Autostick in stock form,in drive turned several 15.50s at 89.50,with a .025 hole in the orange hose,it went 15.33 at 91.44(13 lbs. of boost,droping to 9 lbs.) Old Head

[COP TZER]

i'm dying to take my car to the track and do some passes...But i can tell you this, it's beating an MK3 VR6 with intake, full exhaust, GIAC X-chip, and minor internal mods...[^]

[ptcruzin42]

chip? where from?

[Chipmunk]

14.7 @ 94mph - Manual Boost Controller 15psi Dropping to 13psi.

No engine Pre-Load & Traction Controll On.

Also no back seats.

60' time 2.2 Seconds - Need Better Tires and Smaller Rims for the Track.

Matt

[COP TZER]

i should probably clarify, the chip isn't in my car. Although i wish it was...those mods are in the VR6 Jetta...

[old head from phila.]

Chipmunk;You are flying what do you have done,If you have been reading my posts,I have tryed many boost controlers and lets say i have my Hallman on at 3 1/2 turns in i get a flash reading of 15 drops to 12 fast,then continues droping to 8,this is hiting it in drive at 30 mph. Old Head

[Ian-PT-GT]

Old head,
Time to go with electronics!
I still dont have complete test info but i am loving it!

Ian

[old head from phila.]

I forgot to post my 1/8 mile times 9.82 at 71.06 with .025 hole in orange hose OLD HEAD

[ptcruzin42]

what is this hole in the orange tube mod?

[Ian-PT-GT]

It is also called a "bleed hole". It is a small hole used to vent a little presure out of the line and let the turbo spool a little longer before the wastegate opens. I have seen this trick before but with aquarium checkvalves. It works nice but the only downside is that once the hole is done, you cannot adjust it.

Ian