Pillar Pod and Gauges

[Big Al]

quote:Originally posted by CJJ

check with TThrift. Chrysler has a spray can with color to match the interior

I checked with my local dealer. He stated there was no such product - just exterior paint cans. Of course my local dealer's parts guy is not known by me to think outside of the box...

[tom-t-rifik]

Here's a quote from an earlier thread concerning this same question:

The gray paint part # is 5072272AA and the primer part # is 4443633 and any local dealer or myself can order these for you; just clean the pod with alki first then prime 2 or 3 coats then 2 or 3 coats of paint and you are good to go. -tthrift

[RallyDRock]

quote:Originally posted by PTGT Redman

RallyD, the yellow wire for the tap for the EGT goes to what fuse source?

not sure but it is switched with the ignition. it shouldnt matter because the current draw is very low, its just to operate the gauge.



quote:
Originally posted by Mean Green
I'm a bit lost (sometimes since birth). Why am I yanking this off?

you'll need to take off the lower panel too if you want to send wires through the hood release grommet

[Mean Green]

quote:Originally posted by RallyDRock

not sure but it is switched with the ignition. it shouldnt matter because the current draw is very low, its just to operate the gauge.



quote:
Originally posted by Mean Green
I'm a bit lost (sometimes since birth). Why am I yanking this off?

you'll need to take off the lower panel too if you want to send wires through the hood release grommet

Thanks